Every appliance. One diagnostic-first repair process.
Six appliance categories. Each with its own fault protocol, OEM parts, and a technician who knows the difference between a sensor fault and a control board failure.
Category-specific protocols, not guesswork.
Washing Machines
Refrigerators
Ovens & Cooktops
Motor load testing, drum bearing inspection, and door-seal diagnosis before any part is quoted or replaced.
Compressor pressure readings, refrigerant charge check, and thermostat calibration measured before any component is touched.
Element resistance testing, ignition sequence verification, and control board fault-code retrieval on every job.
Dryers
Dishwashers
Smart Appliances
Airflow restriction measurement, heating element continuity check, and drum rotation torque verified before parts are sourced.
Firmware version checks, sensor calibration, and Wi-Fi module diagnostics — connected devices need more than a spanner.
Pump pressure, spray arm flow, and water inlet valve actuation all tested against spec before diagnosis is closed.
No substitutes. No shortcuts.
Every repair uses manufacturer-spec parts sourced from authorised distributors. Third-party substitutes cost less upfront and fail faster — we don't carry them.
Parts are confirmed against the appliance's model number before the visit. If it's not in stock for same-day work, we tell you before we arrive — not after.
One visit. Right part. Finished before it becomes a second appointment.
Know the fault. Bring the part. Fix it once.
Tell us which appliance and what it's doing. We'll confirm the appointment, the diagnostic approach, and parts availability before the technician leaves.